Как Crimp гидравлический шлангs: 7-Step Quick Reference

How to crimp hydraulic hoses — it is one of the most common questions on r/Hydraulics. The process is straightforward, but skipping steps causes leaks. Whether you use a hydraulic hose crimper or a manual unit, the same 7 steps apply. Here is the quick reference.

шаг 1: отрезать Hose очистить

Cut the hose square using a hydraulic hose cutting machine or a chop wheel with a fine-tooth blade. A square cut means the fitting seats straight. For proper hose construction types, refer to the hydraulic hose reference.

Safety: Wire braid and spiral hose fray on contact. Wear cut-resistant gloves.

шаг 2: выбрать Correct Die

Match the die to the hose size and fitting type. Each crimper die has a size stamp (e.g., P16/14 for 14 mm ID). Using the wrong die is the #1 cause of crimp failures — one Reddit user found their Amazon crimper’s dies didn’t match copper flare connectors and had to improvise with a smaller die, a gamble on pressure rating.

Always cross-reference the die таблица from the производитель. размер матрицыs are not universal across brands.

шаг 3: снять изоляцию если Required

For interlock and some one-piece fittings, strip the rubber cover to expose the wire braid using a hose skiving machine. Skip this on skiveless fittings — but confirm which type you have before starting.

Step 4: Insert фитинг and обжимная гильза

Lubricate the fitting stem with assembly lube. Push the fitting into the hose until it bottoms out. Slide the ferrule over the hose end. The ferrule should sit flush — any gap means the fitting isn’t seated. For fitting thread standards (BSP, metric, SAE), check the ISO 8434 reference.

Safety: Do not lubricate with oil or grease if the hose carries hydraulic fluid. Contaminants degrade hydraulic fluid and seal compounds.

Step 5: Set диаметр опрессовки

Look up the crimp diameter in the manufacturer’s spec chart. Set the die position on your hydraulic crimper to this diameter. On CNC machines, enter the value. On manual units, adjust the die holder.

Step 6: Run the цикл опрессовки

Place the hose into the die set with the fitting stem facing up. Close the die cage and run the cycle. A manual hydraulic hose crimping tool takes about 10 seconds; electric machines complete in 6–8 seconds. The crimp creates a cold-weld bond between ferrule and fitting.

Safety: Keep hands clear of the die area during crimping. The radial force can exceed 100 tons on larger machines.

Step 7: Measure and испытание давлением

измерять crimped diameter при three points с a vernier caliper. сравнить до spec — TRCrimp станки hold ±0.03 mm допуск, well до industry average of ±0.125 mm. если off, отрегулировать die и start свыше с a новый фитинг. Do не re-опрессовать тот же hose.

Pressure test at 2× working pressure following SAE J517 proof test requirements. A proper crimp holds without weeping, swelling, or fitting movement.

Common MЛиtakes to Avoid

Похожие статьи

Hydraulic Hose Crimping Machine Setup Complete setup guide from unboxing to first crimp — tools, calibration, and testing.	Hose дефект опрессовкиs: 6 Common MЛиtakes Why crimps leak and how to fix each failure mode — with photos and corrections.
5 качество опрессовки Checks Every оператор Should Do Quality checklist from real production floor — caliper, visual, pull test, and more.	Станок для опрессовки РВД Starter Kit Everything you need for the first 100 assemblies — complete shopping list.